Connection From CX-Supervisor v2.0

This tutorial is intended to give you an overview of connecting CelciuXº to the PC using CX-Supervisor in order to monitor values.

Components used:
• EJ1N-TC__-__
• 24 Volt Supply
• E58-CIFQ1
• CX-Supervisor v2.0


  • Connect the CelciuXº using the procedure described in “Connection to CX Thermo via USB port”.
  • Install CX-Supervisor v2.0 (this also installs the EJ1 CX-Server driver)
  • Start CX-Supervisor developer and create a new project
  • Add a new device ( )for the EJ1

  • Add points to the project ( ) for the EJ1. For definition of point addressing, see the help file under “Start | Programs | Omron | CX-Server | Drivers | EJ1 Driver help”

  • To display the value, add a new page to your project:

  • Then add a graphical control such as a rotational gauge:

  • The properties of this can be set to display your new point:

  • Ensure your EJ1 is connected correctly and then run your project ( ). Please note, CX-Supervisor requires a USB dongle to be connected in order to run your project. These instructions are also applicable to the trial version of CX-Supervisor which does not require a dongle, but will only run for 30 days. 

  • You can now Read and Write parameters of the connected CelciuX temperature controller