Introduction
This tutorial is intended to give an overview of connecting CelciuXº to NS and using Smart Active Parts with the HMI.
| Components used: • EJ1N-TC__-__ • EJ1C-EDU_-NFLK • 24 Volt Supply • CJ1W-CIF11 • NS_ -T__ Serial or USB cable to program the HMI • E58-CIFQ1 for configuration of CelciuXº |
 |
Procedure:
- Setting the CJ1W-CIF11: Set the dip switches as follows
SW2 Description 1 ON: Terminator connected. 2 ON: 2-wire method 3 ON: 2-wire method 4 Not used. 5 OFF: No RS control of RD (continual reception) 6 ON: RS control of SD - Connect the CJ1W-CIF11 (RS485 port) to the B port of the EDU.
RDB+ __ B+; RDA- ___A-; 110Ω to 125 Ω 1/2W terminating resistor - Set NS Application Comms settings as (in CX Designer) NS version 6.6 of firmware; CX Designer V2.01 or above.
- Write the CX designer Application by including the appropriate SAPs
The current SAP library includes (Status Monitor, Settings, Faceplate and operation commands)
- Configure the Temperature Controllers with CX-Thermo.
- Download the application to the NS
- HMI can now be used for commissioning, operation and maintenance of the instruments.
