Procedure:

• Connect the CelciuXº using the procedure described in “Connection to CX Thermo via USB port”.
• Install CX-Supervisor v2.0 (this also installs the EJ1 CX-Server driver)
• Start CX-Supervisor developer and create a new project
• Add a new device ( )for the EJ1
  
  
• Add points to the project ( ) for the EJ1. For definition of point addressing, see the help file under “Start | Programs | Omron | CX-Server | Drivers | EJ1 Driver help”
  
  
• To display the value, add a new page to your project:
  
  
• Then add a graphical control such as a rotational gauge:
  
  
• The properties of this can be set to display your new point:
  
  
• Ensure your EJ1 is connected correctly and then run your project ( ). Please note, CX-Supervisor requires a USB dongle to be connected in order to run your project. These instructions are also applicable to the trial version of CX-Supervisor which does not require a dongle, but will only run for 30 days. 
  
  
• You can now Read and Write parameters of the connected CelciuX temperature controller