Industrial Automation
Industrial Automation | Europe

myKnowledge

Main > Product Type > Software > Visualisation
Minimize Text   Default    Enlarge Text
 

Print
E-mail

How To Configure Communication To SYSMAC Board in CX-Supervisor


Introduction
At present, CX-Server (v1.0 / 1.1) can not find drivers for SYSMAC Board. However, this can be worked around by defining the SCS in FINSGateway. In this case, Network Type is also FINSGateway. The Settings button is used to define the Node number which must be <= 126 Network and the Unit must be 0.
 
NOTE! SCSs involved should not be the FGW SysmacBoard driver ie it must separately purchased / installed.

In the SYSMAC Board Properties window change the default 'Node number (230) for the same number as the SCS in the example: 101.  In the window below this a FGW Service Manager  displays a FGW Network Navigator button below which identifies the card, and the Properties button. 

FINSGatewayn SysmacBoard Unit must be on so that traffic operates

Variables that can be used in this case are the DM and the CIO (IR).

 




Comments (View All Comments / Add Comment)

Related Articles
No related articles found.
Created 2009-06-04
Modified 2009-06-04
Views 2898

 

You are not logged in.